Water leak detected — moisture in the drip tray
The LE error on the Samsung WF50A8600AV indicates water leak detected — moisture in the drip tray. This typically occurs due to loose or damaged water supply hose connection. Most homeowners fix this in 20–40 min by following the steps below.
Safety Warning
This is a high-severity error. Unplug the appliance immediately and assess the situation before attempting any repair.
Common Causes of LE
- 1Loose or damaged water supply hose connection
- 2Cracked or torn door boot seal (rubber gasket)
- 3Detergent dispenser leaking during wash
- 4Internal hose clamp loose
How to Fix LE
- 1
Step 1
Power off the washer and pull the plug immediately
- 2
Step 2
Turn off both water supply valves behind the washer
- 3
Step 3
Check the floor around and under the washer for visible water
- 4
Step 4
Inspect both water supply hose connections at the back — tighten if loose
- 5
Step 5
Open the door and run your hand around the rubber door seal checking for tears or cracks
- 6
Step 6
Remove the detergent dispenser drawer and check for cracks or clogs causing overflow
- 7
Step 7
Clean and dry the drip tray area at the bottom of the washer if accessible
Tools Needed
When to Call a Technician
No visible leak found but the error keeps appearing — an internal hose or clamp may be loose and needs access to the internal components
Frequently Asked Questions
Common questions about Samsung LE error
Open the washer door and fold back the large rubber gasket (boot seal) around the door opening. Run your fingers slowly all the way around — feel for any tears, cracks, or thin spots. Also check the bottom of the seal where water pools — this is the most common spot for deterioration. Shine a flashlight to spot small cracks that your fingers might miss.
Potentially. The washer detects moisture early and stops the cycle before a full flood, but some water may have already leaked underneath. Check the floor immediately — even a small amount of water sitting under the machine for days can damage wood flooring or promote mold growth. Dry the area thoroughly and monitor for the next few days.
A replacement door boot seal for Samsung front-load washers typically costs $50 to $120 for the part. Professional installation adds $100 to $200 because the repair involves removing the front panel and re-clamping the seal around both the tub and the door frame. This repair is possible as a DIY project, but the clamp spring can be tricky to work with.
Was this guide helpful?
Help us improve our repair guides